1991 Chevrolet S-10 Red S10













Vehicle Description
1991 Chevrolet S10 4.3L 2WD (Local PU)
Vehicle Details
Up for auction is a 1991 Chevy S10 4.3L 2WD, maroon exterior, maroon interior. It was my daily and my pride & joy. Unfortunately I have too many projects, and recently I have been having a hesitation with a misfire, low oil pressure is detected (no engine knock)-put a new AC delco oil switch still showing low. There are no codes on the OBD 1 system for me diagnose. I replaced almost all sensors including the ECM, Memcal, Calpak chips, still no help with hesitation and misfire. Then while driving it, the transmission front pump seal or torque converter went out and was pouring transmission fluid from the bell housing. I saved the transmission by having turning it off when I detected the leak. So I would say this is a mechanic special, the truck is complete and all there. The other cons is rust holes on the driver floor pan and extended cab, those areas have a metal plate, to do it the correct way, they need to be cut out and put new floor pans. Like I said it's really nice but needs alot of work. If fixed these trucks are increasing in value at time goes on. So bring a trailer, and I can put transmission fluid to load it on the trailer. If purchased I accept cash, or money order, and can sign clean blue title (besure to check your title transfer on your state-each state is different).
Listing is the Pros: Most new sensors-coolant temp sensor, IAC, TPS, EGR solenoid, oil pressure switch, New 3 core all aluminum radiator with 160° thermostat, new distributor and cap, fairly new plugs and wires 0.35 gap, new fuel pump with fuel filter. I set the timing to 2° advance, it has roller tip rockers 3/8 1.6, stage 2 Jet performance chip, Fram washable Air Hog, hollowed out cat, new serpentine belt, has electric fan on Ac compressor demand, transmission cooler with gauge, Rear sway bar (red), 110 mph cluster swap-it all works, 3rd brake light (flashing), All power windows and locks work, cruise control works, map lights work, Ac compressor/accumalator/orfice filter Pag oil-replaced-blows cold but has a slow leak, 2024 Battery, Transmission has a sonnex sunshell and corvette servo with new speed sensor, amp wiring in the truck for a boom box...
Listing is the Cons: Motor has a slight backfire through the intake (maybe misfire)-timing is 2°, low oil pressure-no sludge in the engine-regular oil changes (synthetic)-doesn't burn oil or no blow by, Ac has a slow leak, maybe the front compressor, non positrac on the rear, Transmission has a major leak at either the torque converter or front pump seal, will need the 8647058 Waved Forward Clutch Plate for smoother reverse to forward gear. Driver floor pan needs to be replaced or patch, same with extended cab floor pan-replaced or patched, and of course needs paint-on the cab has rust bubbles-used bondo but rust comes back...
Like I said this a project, a mechanic special, would make for a great LS Swap or rebuild it. These trucks were well built and their value is higher than the next generation S-10's. So bring a trailer....Thanks for looking and happy bidding
Location: Corpus Christi TX 78412