1978 Jeep CJ-7 RENEGADE 1978 Jeep CJ-7 RENEGADE - photo 2 1978 Jeep CJ-7 RENEGADE - photo 3 1978 Jeep CJ-7 RENEGADE - photo 4 1978 Jeep CJ-7 RENEGADE - photo 5 1978 Jeep CJ-7 RENEGADE - photo 6 1978 Jeep CJ-7 RENEGADE - photo 7 1978 Jeep CJ-7 RENEGADE - photo 8 1978 Jeep CJ-7 RENEGADE - photo 9 1978 Jeep CJ-7 RENEGADE - photo 10 1978 Jeep CJ-7 RENEGADE - photo 11 1978 Jeep CJ-7 RENEGADE - photo 12 1978 Jeep CJ-7 RENEGADE - photo 13

Vehicle Description

78 Jeep CJ-7 Renegade with factory v8 automatic and Quadra-Trac AWD- All major mechanical systems have been replaced or rebuilt. Delivery available for additional cost.

New last 2 yrs/1500 miles-

Professionally rebuilt 304 V8 with 4bbl Edelbrock Carb.

HEI distributor conversion

Rebuilt steering column with new wiring, ignition switch, steering wheel, horn, turn signal switch, etc.

Aluminum radiator, hoses, thermostat etc.

Renegade decal kit

All new single exhaust from manifolds with dynomax muffler (no cat) Nice v8 rumble but not too loud

Starter, alternator, high flow water pump, etc.

Fuel tank & pump, filler hoses etc.

Painless wiring harness plus additional wiring replacement as needed

Tail lights/blinkers

5 new 31x10.50 Goodyear MT

Wiper motor switch and pump

Heater cables and knobs

Bestop bikini top

Runs and drives and sounds great

No top or doors

Factory v8 Automatic with Quadratrac (full time 4wd)

PS,PB

Stock suspension body mounts etc

Small spots of surface rust and/ or dings all over consistent with a 47yr old car but looks great overall

Repainted in the past

One rust spot on passenger floorboard about 1”x2” otherwise solid tub

Surface rust on frame and peeling undercoat but no major spots that I could find

Tailgate hinges are frozen from rust

Transmission is GMTH400 3 spd (rebuilt age unknown) shifts good

NEEDS-

Has new reproduction gauges but they aren’t reliably reading currently. I was planning on getting a speedhut gauge setup for all of them but haven’t gotten around to it.

No stereo but has the 6x9 pods behind the seats and new wiring ready. I was going to do a retrosound Bluetooth two shaft oem look

Seats are fine but I was going to replace them with nicer ones

A gear indicator for the column

A brake pedal cover

Odometer stopped true miles unknown